TensorGrip F31

TensorGrip F31

Tensorgrip F31 is a high performance spray adhesive developed for demanding foam, fabric, leather and upholstery applications. Its tough curing properties and high temperature resistance give ultra-strong bond adhesion when working in high demand, bespoke upholstery applications, ensuring longevity and excellent, integral bond results.

TENSORGRIP F31 ADVANTAGES

• Exceptional, tough curing bond lines.
• High temperature resistance – 118°C.
• Fine web spray pattern reducing bleed through on thin fabrics.
• Highly controllable spray pattern for varying surface areas.
• Excellent green strength and low odour.

TENSORGRIP F31 DIRECTIONS FOR USE

• This product is designed to be applied to two surfaces to be bonded together. Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc. For best results, the temperature of the adhesive and the surfaces being bonded should be between 16°C – 27°C.
• Use with adequate ventilation. When possible
  we recommend shaking the canister well before using. Attach and secure hose tightly onto the spray gun with the required tip. Attach the other end of the hose onto the canister. Make sure the hose-valve connections are securely tight. Open the valve on the canister slowly and fully, check for leaks during this process. Unlock the trigger on the spray gun to start spraying.
• Prior to use, Check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates. Spray about 10-20 cm away at a 90 degree angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. If necessary, spray another coat of adhesive in areas that appear to need more adhesive. Spray both surfaces to be bonded, one surface vertically and the other surface horizontally. Allow the adhesive to tack off until no adhesive transfers to the knuckle when touched.
• Adhere surfaces and press together with adequate pressure. A roller is recommended to apply a uniform pressure to achieve maximum strength. Allow 24 hours for the adhesive to fully cure.
• If the spray tip clogs, unscrew the spray tip from the gun and clean with solvent such as lacquer thinner or TensorGrip S105 acetone cleaner. Do not use a pin on the spray tip orifice.

TENSORGRIP F31 CANISTER STORAGE/CHANGE OVER

• If you choose to leave the hose and spray gun on the canister, leave the valve on the canister open. Do not disconnect the hose/gun from the canister. Close and lock the spray gun.
• To change or disconnect canister: turn canister valve to the off position, spray out remaining adhesive left in the hose, disconnect the spray hose and gun from the canister.
• Reconnect the spray hose to a new canister of adhesive. OR if you are NOT connecting to a new canister, connect hose to canister of cleaning solvent (sold separately) and spray out until liquid is clear which indicates that the hose and gun is clean.

TENSORGRIP F31 SPECIAL PRECAUTIONS

For optimum results store canister above 18°C during use, but must always be above 10°C. Allow substrates to acclimatise to normal room temperature (18°C) for 48 hours before bonding. Do not exceed open time of the adhesive. Keep canister off cold concrete floors during use. If adhesive is expelled wet or as a jet, canister is too cold – move to warm environment and allow to thoroughly acclimatise before reusing.

TENSORGRIP F31 KICK OFF KIT

TensorGrip Kick Off Kits are available for first time customers only. An example of the supplied kit is shown within the image gallery above. Only first time customers are eligible to receive a one off FREE kit. As soon as your online order has been placed your details will be cross referenced with our database of existing registrants. Once validated a free kit will be supplied with your Canister or Jumbo order of TensorGrip F31. Note that Kick Off Kits are not supplied with Aerosol products.