TensorGrip F40

TensorGrip F40

Tensorgrip® F40 is a highly aggressive adhesive for all demanding foam, fabric, upholstery and carpet applications. F40 is a Non-Chlorinated, high-solid, synthetic rubber spray grade, multi-purpose glue in canisters. This adhesive is designed for versatility with a long open time and high tack level with excellent strength for bonding a wide variety of substrates, including foam, fabrics, leather, upholstery, plywood, MDF and many others. F40 can be used single-sided to bond webbing to foam.

Tensorgrip F40 Advantages

  • Non-Chlorinated Adhesive
  • HAPS Free
  • Extremely high tack
  • Full strength achieved in 24 hours
  • 80% of final power immediately
  • Repositionable
  • Single-sided or Double-sided
  • Polystyrene Safe

 

Tensorgrip F40 Directions For Use

  • This product is designed to be applied to surfaces and bonded together unless otherwise specified. Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc. For best results, the temperature of the adhesive and the surfaces being bonded should be between 16°C – 27°C.
  • Use with adequate ventilation. We recommend shaking the canister well before using it. Attach and secure the hose tightly onto the spray gun with the required tip. Attach the other end of the hose to the canister. Make sure the hose-valve connections are securely tightened. Open the valve on the canister slowly and thoroughly, and check for leaks during this process. Unlock the trigger on the spray gun to start spraying.
  • Before use, Check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates. Spray about 10-20 cm away at a 90-degree angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% character coverage. If necessary, spray another coat of adhesive in areas that need more adhesive. Spray both surfaces to be bonded, one surface vertically and the other surface horizontally. Allow the adhesive to tack off until no adhesive transfers to the knuckle when touched.
  • Adhere surfaces and press together with adequate pressure. A roller is recommended to apply a uniform pressure to achieve maximum strength. Allow 24 hours for the adhesive to fully cure.
  • If the spray tip clogs, unscrew the spray tip from the gun and clean with a solvent such as lacquer thinner or TensorGrip® C101 citrus cleaner. Do not use a pin on the spray tip orifice.

Terms of Sale

  • There are no refunds or exchanges for this product.
  • We no longer ship to residential addresses.
  • Free freight applies to metro zones only.
  • Customers must download and read through the available MSDS documents 

Ordering

SKU OA-TG-F40 Categories ,

$416.00$3,339.00 Ex GST

Spray Guide

Brochure

MSDS

TDS

Tip Guide

Cleaning

You may also be interested in...